The downtime that kills you is not the big breakdown. It is the hundred little stops nobody writes down.
A jam cleared in thirty seconds. A changeover that ran long. A sensor that needed a tap. None of them feel worth logging. Each one is trivial. Together they can quietly eat ten or twenty percent of your capacity, and they never show up in the downtime report because individually they were too small to count.
That is what makes micro-stops so dangerous. The big failure gets a meeting and a root cause. The micro-stop gets a shrug. So the big one gets fixed and the expensive one keeps happening, shift after shift, invisible.
If you only measure the stops big enough to hurt on their own, you are missing where most of your lost output actually goes.
Death by a thousand cuts is still death.
Do you actually capture the small stops on your line, or only the ones big enough to notice?
Originally posted on LinkedIn by Karl Mudespacher. See the post and the discussion on LinkedIn.






